When I open up the Macroes Editor to modify or check which macroe is enabled etc the message comes up
Run-time error '75': Path/File access error
and then the crit gets booted
have updated etc and re-installed, and have heaps of room in the hard-drive etc
any suggestions on how to get around this, or what it means?
Run-time Error '75':
Started by lowmion, Jun 22 2006 03:09 AM
3 replies to this topic
#1
Posted 22 June 2006 - 03:09 AM
#2
Posted 22 June 2006 - 11:22 AM
I think I got that problem a while back. I had restored my comp to a former state (before a update/reinstall I believe). I backed up my directory for macro's, onto another HD. I 'think' the problem was that I had made the files read-only, during the original transfer... and when copied back, NM couldn't change them.
#3
Posted 22 June 2006 - 12:01 PM
A memo from Evaporate on 06-22-2006 12:24:56 saying: (macro issue), check to make sure the txt files in your NM directory, for your macro's, are not read-only.
Thanks mate, yup I'ld accidently set the files to archive and read only.
All fixed now
Thanks mate, yup I'ld accidently set the files to archive and read only.
All fixed now
#4
Posted 23 June 2006 - 11:16 AM
I don't think it used to do that... I seem to recall having a problem changing my macro's at one point (shortly after starting). Only problem was, I changed it, and changed it, and it never showed after saving, finally noticed that...... (about same time I realized that macro's were saved to a txt file.... lol)
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users