3 replies to this topic

[lowmion]

When I open up the Macroes Editor to modify or check which macroe is enabled etc the message comes up

Run-time error '75': Path/File access error

and then the crit gets booted

have updated etc and re-installed, and have heaps of room in the hard-drive etc

any suggestions on how to get around this, or what it means?

[Evaporate]

I think I got that problem a while back. I had restored my comp to a former state (before a update/reinstall I believe). I backed up my directory for macro's, onto another HD. I 'think' the problem was that I had made the files read-only, during the original transfer... and when copied back, NM couldn't change them.

[lowmion]

A memo from Evaporate on 06-22-2006 12:24:56 saying: (macro issue), check to make sure the txt files in your NM directory, for your macro's, are not read-only.

Thanks mate, yup I'ld accidently set the files to archive and read only.

All fixed now

[Evaporate]

I don't think it used to do that... I seem to recall having a problem changing my macro's at one point (shortly after starting). Only problem was, I changed it, and changed it, and it never showed after saving, finally noticed that...... (about same time I realized that macro's were saved to a txt file.... lol)